Directly Outputting An Input Channel - Yamaha CL5 Reference Manual

PORT SELECT screen
Displayed when you press either the INSERT OUT or INSERT IN button in the one-channel
or the eight-channel INSERT/DIRECT OUT window. Set the input/output port used for
insertion.
1
1
Category select list
Selects the category of port. The categories correspond to the following ports. The
displayed categories vary depending on the channel
• OMNI...................................... OMNI1 - OMNI8
• SLOT1 .................................... SLOT1(1) - SLOT1(16)
• SLOT2 .................................... SLOT2(1) - SLOT2(16)
• SLOT3 .................................... SLOT3(1) - SLOT3(16)
• GEQ RACK ............................ GEQ1L(A) - GEQ16R(B)
(MIX/MATRIX/STEREO/MONO channels only)
GEQ1L(A) - GEQ8R(B) (INPUT channels only)
• EFFECT RACK ...................... FX1L(A) - FX8R(B)
• PREMIUM RACK ................... PR1L(A) - PR8R(B)
2
Port select buttons
Assign the port that will be used as insert-out/insert-in for the currently-selected
channel.
NOTE
If a rack in which a GEQ, PEQ, or Premium Rack is mounted is specified as the insert-out or
insert-in, the other patch point will automatically be assigned to the same rack. Also, insert mode
will automatically be switched on. Additionally, if you defeat the insert-out or insert-in of a rack in
which a GEQ, PEQ, or Premium Rack is mounted, the other patch point will automatically be
defeated and at the same time insert mode will automatically be switched off.
3
CLOSE button
Closes the screen.
2
3
type.
23

Directly outputting an INPUT channel

The signal of an INPUT channel can be output directly from an OUTPUT jack on the I/O
device, from the desired OMNI OUT jack, or from the output channel of a desired slot.
STEP
1. Connect your external device to an OMNI OUT jack, OUTPUT jack, or to an I/O card
installed in slot 1-3.
2. Use the Bank Select keys in the Centralogic section to select the input channel that
you want to output directly.
3. Press the INSERT/DIRECT OUT field in the OVERVIEW screen.
4. Press the DIRECT OUT PATCH button in the INSERT/DIRECT OUT screen.
5. Select an output port.
OVERVIEW screen
NOTE
If you install a digital I/O card in a slot and digitally connect an external device, you must
synchronize the word clock of the CL console and the external device
Input and output patching
INSERT/DIRECT OUT Screen (8ch)
(page 218).
Reference Manual