Oscillator Screen - Yamaha PM5D Owner's Manual

I BUS ASSIGN
Here you can select the bus(es) or output jack(s) from
which the talkback signal will be sent. (Multiple selec-
tions are allowed.)
MIX 1–24 . . . . . . . . MIX bus 1–24
MATRIX 1–8 . . . . . MATRIX bus 1–8
ST A L/R . . . . . . . . . STEREO A bus L/R channels
ST B L/R . . . . . . . . . STEREO B bus L/R channels
J TALKBACK OUT (Talkback direct output)
This indicates the channel of the output jack / slot that
is selected as the output destination for direct output of
the talkback signal. If more than one output destina-
tion is patched, "..." will be displayed following the
name of the output destination that was found first. If
you want to change the output destination, click the
PATCH button to access the OUTPUT PATCH screen.

OSCILLATOR screen

'Here you can make settings and perform operations
related to the internal oscillator.
OSCILLATOR
9
J
1
A OSC ON/OFF (Oscillator on/off)
Turns the Oscillator on/off. This is linked with the
OSCILLATOR [ON] switch of the top panel.
B OSC MODE (Oscillator mode)
These buttons select the waveform or type of noise pro-
duced by the oscillator.
SINE WAVE 1CH . Sine wave x 1 channel
SINE WAVE 2CH . Sine wave x 2 channels
PINK NOISE . . . . . Pink noise
BURST NOISE . . . . Burst noise (repeated output of
C PARAMETERS
Here you can set various items according to the selec-
tion in (
PM5D/PM5D-RH Owner's Manual
2
3
pink noise)
2 ).
Reference section
213