Gain/Attenuation/Ø (Gain / Attenuation / Phase); Noise Gate - Yamaha PM5D Owner's Manual

GAIN/ATTENUATION/ø (Gain /
Attenuation / Phase)
Here you can edit the head amp, post AD conversion
attenuator, and phase parameters for the currently selected
channel. This section is available only if an input channel is
selected.
1
2
A A[GAIN/ATT] key
This key selects the parameter that is controlled by the
2 ).
[GAIN/ATT] encoder (
• [GAIN/ATT] key lit (Gain)
The encoder adjusts the input sensitivity of the inter-
nal head amp patched to the input channel (PM5D-
RH only) or of an external head amp that supports the
dedicated protocol (Yamaha AD8HR, AD824, etc.).
The range of adjustment is +10 to –62.
• [GAIN/ATT] key dark (Attenuator)
The encoder controls the post AD conversion attenua-
tor of the input channel. The range of adjustment is
–96 to +24.
Note
Gain cannot be selected for channels to which an internal/
external head amp is not patched.
B [GAIN/ATT] encoder
According to the setting of the [GAIN/ATT] key (
this encoder controls either the input sensitivity of the
internal/external head amp patched to the input chan-
nel, or the attenuator following AD conversion.
The LEDs around the periphery will change as follows.
• [GAIN/ATT] key lit (Gain)
➠
• [GAIN/ATT] key dark (Attenuator)
➠
–
(attenuation)
C [ø] key
This switches the phase of the selected input channel. If
this key is on, the phase will be reversed.
3
1 ),
➠
0 +
(boost)
PM5D/PM5D-RH Owner's Manual

NOISE GATE

Here you can edit noise gate parameters for the selected
channel. This section is valid only if an input channel or ST
IN channel is selected.
1
2
9
A GATE GR meter
This meter indicates the amount of reduction pro-
duced by the gate of the selected channel.
B GATE [ON] key
Switches the gate on/off for the selected channel.
C GATE [ATTACK] indicator
Indicates the attack time of the gate in msec units.
D GATE [ATTACK] encoder
Specifies the attack time of the gate (the time from
when the signal exceeds the threshold until the gate
opens).
E GATE [HOLD] indicator
Indicates the hold time of the gate in msec units or sec
units (the indicator for the displayed unit will light).
F GATE [HOLD] encoder
Specifies the hold time of the gate (the time from when
the signal falls below the threshold until the gate
closes).
G GATE [DECAY] indicator
Indicates the decay time of the gate in msec units or sec
units.
H GATE [DECAY] encoder
Specifies the hold time of the gate (the time over which
the gate will close after the hold time has elapsed).
I GATE [THRESHOLD] encoder
Specifies the threshold level of the gate (the level at
which the gate will open or close). The gate will open
when the signal exceeds this level, and will close when
the signal falls below this level.
J GATE [RANGE] encoder
Specifies the amount of attenuation while the gate is
closed.
Operating section
3
4
5
6
7
8
J
7
59