Output Functions; Output Patch Function; Output Patch Screen - Yamaha PM5D Owner's Manual

Output functions

OUTPUT PATCH function

OUTPUT PATCH screen

Here you can make patch settings to send output channel
signals to the outputs of I/O cards installed in the slots, to
the input of internal effects, and to the 2TR OUT DIGI-
TAL jacks.
OUTPUT PATCH
1
2
A SELECTED PATCH
This indicates the output channel number and output
port of the grid at which the cursor is located.
B CH (Output channel)
This is the number of the output channel (MIX chan-
nel, MATRIX channel, STEREO A/B channel,
MONITOR L/C/R channel, TALKBACK OUT chan-
nel, OSC OUT channel) whose output destination will
be patched. The channel number at which the cursor is
located will be highlighted.
C ASSIGN
For each output channel, this indicates the number of
output ports that are currently assigned.
D Grid
This grid lets you patch output ports (horizontal rows)
to output channels (vertical columns). Currently-
patched grids are indicated by a
a grid location you can set/cancel patching.
220
PM5D/PM5D-RH Owner's Manual
Output functions
5
3 4
symbol. By clicking
Reference section
The red lines at the left and top indicate the grid loca-
tion to which you move the cursor.
Hint
• If PATCH CONFIRMATION is turned on in the PREFER-
ENCE 1 screen (UTILITY function), a confirmation message
will appear each time you attempt to change a patch set-
ting. If STEAL PATCH CONFIRMATION is turned on, a
confirmation message will also appear when you attempt to
make patch settings that would cause an existing patch to
be modified.
• To move the cursor location rapidly in or out of the grid, hold
down the [SHIFT] key and press the CURSOR [ √ ]/[ ® ]/[ π ]/
[ † ] keys.
• To move rapidly to left or right inside the grid, turn the
[DATA] encoder. To move up or down, hold down the
[SHIFT] key and turn the [DATA] encoder.
Note
You can patch an output channel to more than one output
port, but you cannot patch multiple output channels to a sin-
gle output port.
E Output port
From the top, this area indicates the type of output
port, the ID number, the output channel number, and
the number of output channels assigned. The follow-
ing types of output port can be selected.
Output channels of an I/O card installed in slots
SLOT OUT
1–4
L/R inputs of internal effects 1–8 (MIX chan-
FX IN nels are the only output channels that can be
selected)
2TR OUT L/R channels of 2TR OUT DIGITAL jacks 1–3
F LIBRARY button
This button accesses the OUTPUT PATCH LIBRARY
screen (➥ p.223), where you can store/recall patch
library settings for output channels.
Hint
• The signal from immediately after the delay and immedi-
ately before the output port attenuation will be sent to output
ports you patch in this screen. Subsequently, in the case of
SLOT OUT and 2TR OUT, the specified output port attenua-
tion will be applied respectively.
• The rear panel MIX OUT jacks 1–24, MATRIX OUT jacks 1–
8, and STEREO OUT jacks A/B always output the signal of
the corresponding output channel. They are not affected by
the settings in this screen.
6