80
PERIODIC SERVICE
EVERY 500 HOURS
BReplacing Fuel Filter
Consult your local KUBOTA Dealer for this service.
EVERY 800 HOURS
BAdjusting Engine Valve Clearance
Consult your local KUBOTA Dealer for this service.
EVERY 1500 HOURS
BChecking Fuel Injection Nozzle Injection
Pressure
Consult your local KUBOTA Dealer for this service.
EVERY 3000 HOURS
BChecking Injection Pump
Consult your local KUBOTA Dealer for this service.
EVERY 1 YEAR
BReplacing Air Cleaner Primary Element
and Secondary Element
(See "Cleaning Air Cleaner Primary Element" in "EVERY
100 HOURS" in "PERIODIC SERVICE" section.)
EVERY 2 YEARS
BChanging Brake Fluid
Consult your local KUBOTA Dealer for this service.
(See "Checking Brake Fluid Level" in "DAILY CHECK" in
"PERIODIC SERVICE" section.)
BFlushing Cooling System and Changing
Coolant
To avoid serious injury:
A Do not remove the radiator cap while coolant is
hot. When cool, slowly rotate cap to the first
stop and allow sufficient time for excess
pressure to escape before removing the cap
completely.
1. Stop the engine and let cool down.
2. Open the hood.
3. To drain the coolant, open the radiator drain plug and
remove radiator cap and engine coolant breather. The
radiator cap must be removed to completely drain the
coolant.
4. After all coolant is drained, close the drain plug.
5. Fill with clean water and cooling system cleaner.
6. Follow directions of the cleaner instruction.
7. After flushing, fill with clean distilled water and anti-
freeze until the coolant level is just below the radiator
cap.
Install the radiator cap securely.
8. Fill with fresh distilled water up to the "FULL" mark on
the recovery tank.
9. Close the engine coolant breather.
10. Start and operate the engine for few minutes.
11. Stop the engine and let cool.
12. Check coolant level of recovery tank and add coolant
if necessary.
Coolant capacity
6.1 L (6.4 U.S.qts.)