Every 500 Hours; Replacing Fuel Filter; Every 800 Hours; Adjusting Engine Valve Clearance - Kubota RTV900 Operator's Manual

EVERY 500 HOURS

BReplacing Fuel Filter
Consult your local KUBOTA Dealer for this service.

EVERY 800 HOURS

BAdjusting Engine Valve Clearance
Consult your local KUBOTA Dealer for this service.

EVERY 1500 HOURS

BChecking Fuel Injection Nozzle Injection
Pressure
Consult your local KUBOTA Dealer for this service.

EVERY 3000 HOURS

BChecking Injection Pump
Consult your local KUBOTA Dealer for this service.

EVERY 1 YEAR

BReplacing Air Cleaner Primary Element
and Secondary Element
(See "Cleaning Air Cleaner Primary Element" in "EVERY
100 HOURS" or "EVERY 150 HOURS" in "PERIODIC
SERVICE" section.)

EVERY 2 YEARS

BChanging Brake Fluid
Consult your local KUBOTA Dealer for this service.
(See "Checking Brake Fluid Level" in "DAILY CHECK" in
"PERIODIC SERVICE" section.)
BFlushing Cooling System and Changing
Coolant
To avoid personal injury:
A Do not remove the radiator cap while coolant is
hot. When cool, slowly rotate cap to the first
stop and allow sufficient time for excess
pressure to escape before removing the cap
completely.
1. Stop the engine and let cool down.
2. Remove the protective cover.
3. To drain the coolant, open the radiator drain plug and
remove radiator cap. The radiator cap must be
removed to completely drain the coolant.
4. After all coolant is drained, close the drain plug.
5. Fill with clean water and cooling system cleaner.
6. Follow directions of the cleaner instruction.
7. After flushing, fill with clean water and anti-freeze until
the coolant level is just below the radiator cap.
Install the radiator cap securely.
8. Fill with fresh water up to the "FULL" mark on the
recovery tank.
9. Start and operate the engine for few minutes.
10. Stop the engine and let cool.
11. Check coolant level of recovery tank and add coolant
if necessary.
Coolant capacity
(1) Drain plug
(2) Protective cover
PERIODIC SERVICE
4.0 L (4.2 U.S.qts.)
79