Wavetronix SmartSensor Advance User Manual page 46

Setting Description
Baud Rate Allows you to set the
baud rate for ports 1 and
2. The default setting is
9600 bps.
Port 1 Port usually reserved
(Control) for connecting and
configuring the sensor.
Port 2 (Data) Port usually reserved for
pushing data.
Green Arrow Shows the port over
which SSMA is connected
to the sensor.
Response How long the sensor will
Delay wait before responding
to a received message,
shown in milliseconds.
Remove This should remain OFF
Multi-drop unless you are using
Prefix a device that does not
support a multi-drop
prefix.
Details
Change this to match
the baud rate of the
communication devices
you are using.
Please contact Wavetronix
Technical Support before
changing this setting.
Please contact Wavetronix
Technical Support before
changing this setting.
N/A
The default setting is
4 milliseconds. Please
contact Wavetronix
Technical Support before
changing this setting.
Please contact Wavetronix
Technical Support before
changing this setting.
Chapter 5: Configuring Sensor Settings
45
•