Avaya MERLIN MAGIX Maintenance And Troubleshooting Manual page 400

System Programming Basics
9. Back up the system to a new filename to keep the first backup intact. Use a filename that
describes the post-016 MLX configuration-for example, "post-016 MLX."
Replacing Two 008 MLX Modules with One 016 MLX
Module When the 008 MLX Modules are the Last
Two Modules in the System
Follow these steps when you are replacing two 008 MLX modules at the end of the system with
one 016 MLX module:
1. Back up the system programming to the customer backup card. Use a filename that describes
the pre-016 MLX configuration-for example, "pre-016 MLX."
2. Print a System Setup report. Determine whether the last slot/slots are programmed with
phantom modules. If there are phantom modules, the programming for these modules will be
removed when the new 016 MLX module is implemented.
3. If no phantom modules are programmed, go to Step 4. If there are phantom modules, print all
Extension Information reports for the extensions and MFMs connected to the phantom
modules. The extensions must be re-programmed after the new 016 MLX module is
implemented.
4. Print an Extension Directory report. (This report also includes phantom extension numbers.)
5. Print a Group Calling Information report.
6. Print a Group Coverage Information report.
7. Print Extension Information reports for all ports (including MFMs) on the two 008 MLX
modules that are being replaced.
8. Identify all Inside Auto Dial, Manual Signal, or Extension Pickup buttons programmed on other
telephones that point to the extensions on the 008 MLX module to be replaced. The
programming for these buttons will be removed after the Board Renumber procedure. These
buttons are not shown on the Extension Information report, so you must identify these buttons
with the customer.
9. Power down the system, and replace the two 008 MLX modules with the 016 MLX module.
10. Power up the system.
11. Perform a Board Renumber procedure: Sys Program (1)
Board Renum (4)
12. Print a new Extension Directory report. Verify that the extensions on the new 016 MLX match
those of the previous two 008 MLX modules.
13. Program the extensions and MFMs by using the Extension Information reports printed in
Step 7.
14. Program any Calling Group or coverage group membership, and any buttons identified in
Step 8.
15. If phantom modules were programmed, re-program the phantom modules, as needed using
the information in the Extension Information reports printed in Step 3.
Board Renumbering with the 016 MLX Module
3-48
→
Yes (2).
3
→ →
System (1)