Avaya MERLIN MAGIX Maintenance And Troubleshooting Manual page 363

Internal Connection
To set up a site for an Internal Connection, follow these steps:
1. Using the instructions packaged with your PC modem, verify that the software and hardware
flow control is disabled in the modem properties. This is required when connecting to a
MERLIN MAGIX Release 1.5 or later system, and is recommended for all releases of the
communications system.
2. From the Site Setup screen, click Add. The cursor moves to the Site Name field.
3. Type in the Site Name you wish to use and press the Tab key. Site Names are limited to 30
characters. You may only use characters that are acceptable for file names in the Windows
environment.
4. Complete the following fields to help differentiate this site from any other site(s) that you may
want to add. These fields are not required; therefore, you may fill in as many or as few as you
determine necessary:
– Address
– City
– State
– Postal Code
– Country
– Contact
– Telephone
– Notes
5. Click the Internal Connection tab.
6. Select the Enabled check box. A check mark appears in the box and the Dial String dialog box
is no longer grayed out.
7. Be sure that the Dial String check box displays *10.
8. If you want to add another site, click Add and begin on Step 2 in the process for the
appropriate connection type for the next site.
9. When you finish adding sites, click OK.
If you have multiple modems installed in your system, after clicking OK, you may be
I
prompted to select the modem you want to connect with.
Clicking CANCEL from the Connection Selection screen causes you to return to
I
either the Main screen or the First-Time User Wizard, depending on from where
the screen was started.
About WinSPM
3
Setting Up a Site
3-11