Conclusion Of Hardware Maintenance; Installing The Control Unit Housing (Plastic) - Avaya MERLIN MAGIX Maintenance And Troubleshooting Manual

Conclusion of Hardware Maintenance

At the conclusion of hardware maintenance, replace the control unit housing as follows:
See "Installing/Removing the Cover on the Carrier" in Installation for instructions for a metal
I
carrier.
See

''Installing the Control Unit Housing (plastic)''

I
Whenever you power up a system after working on it, be sure that you power up all
the carriers. If you do not turn on all the carriers, you may cause a cold-start.
Installing the Control Unit Housing (plastic)
After you have completed maintenance and troubleshooting, follow these steps to reinstall the
control unit housing on a plastic carrier.
Installing the Top Cover
To install the top cover, refer to the illustration and follow these steps:
1. Be sure the cords have been pressed through the wire managers at the base of the modules.
2. Hold the top cover with the hooks facing you.
3. Engage the tabs at the rear of the top cover with the carrier.
4. Lower the top cover, so that the legs lock into the vents on the module.
1
below for instructions for a plastic carrier.
1
1

Conclusion of Hardware Maintenance

Getting Started
1-5