Maintenance; Pass-Thru - Avaya MERLIN MAGIX Maintenance And Troubleshooting Manual

Maintenance

CAUTION:
This option is for use by qualified technicians only. Maintenance procedures are provided in
the documentation for qualified technicians.
CAUTION:
This is a password-protected option and is for use by your technical support organization
only.

Pass-Thru

The Pass-Thru option allows qualified service personnel to program IS II/III
100R INA module) on a remote PC. It permits you to establish a remote connection with the control
unit to which the IS II/III PC is directly connected.
A Pass-Thru request must be initiated at a PC; it is not available from a UNIX System PC–that is,
Pass-Thru cannot be established between two IS II/III PCs. The local admin PC must be in an idle
state.
A Pass-Thru request to a locally connected IS II/III system causes the modem to fall back to 1200
bps if the speed is set to 2400 bps and the modem call to the control unit is at 1200 bps. If
necessary, the system adjusts its speed to that of the local SPM PC.
Once the Pass-Thru connection is established, you can program in any of the following IS II/III
applications from your SPM PC:
AUDIX Voice Power
I
Call Accounting System
I
Fax Attendant System (IS III only)
I
CONVERSANT Intro (IS III only)
I
1 Can no longer be ordered.
2 Can be ordered only as an upgrade to existing CAS installations.
®
2
3
3
1
applications (and a
Basic System Management Procedures
About WinSPM
3-39