Avaya MERLIN MAGIX Maintenance And Troubleshooting Manual page 362

System Programming Basics
3. Complete the following fields to help differentiate this site from any other site(s) you may want
to add. These fields are not required; therefore, you may fill in as many or as few as you
determine necessary:
– Address
– City
– State
– Postal Code
– Country
– Contact
– Telephone
– Notes
4. Click the Direct Connection tab.
5. Select the Enabled check box. A check mark appears in the box and the COM Port drop-down
list box is no longer grayed out.
6. Click the arrow located on the right-hand side of the COM Port drop-down list box to get a list
of the available COM ports on your PC. Click once on the number that corresponds to the
COM port on your PC that is connected to the MERLIN MAGIX system programming port.
7. For MERLIN MAGIX systems or MERLIN LEGEND systems Release 3.0 and later, make sure
that 2400 is shown in the Baud Rate combo box. For MERLIN LEGEND systems Release 1.0/
2.0, 1200 baud is recommended.
8. If you want to add another site, click Add and begin on Step 2 in the process for the
appropriate connection type for the next site.
9. When you finish adding sites, click OK.
If you get a message indicating that the cable between your PC and the
I
communications system is not connected, check to be sure that the cable is
connected properly. If the cable is connected properly, try disabling Direct
Connection Detection in the Options screen.
If you have multiple modems installed in your system, after clicking OK, you may be
I
prompted to select the modem you want to connect with.
Clicking CANCEL from the Connection Selection screen causes you to return to
I
either the Main screen or the First-Time User Wizard, depending on from where
the screen was started.
Setting Up a Site
3-10