Power Saver; High Resolution Printing; Edge To Edge Printing - Xerox DocuPrint N24 System Administrator Manual

Special Features

Power Saver

After 60 minutes of inactivity, the printer automatically
turns off internal components to reduce the amount of
electricity used. The printer automatically turns those
parts back on when it receives a print job.
Using the printer's Control Panel menu system, you can
send the printer into Power Saver mode after your choice
of Off, 15, 30, 60, 90, 120 or 180 minutes of inactivity.
See the section "System Menu" (page 3-35) in
Chapter 3: Using the Control Panel.
High Resolution
The DocuPrint N40 is set to print at 600 x 600 dpi (dots
per inch). You can also print draft-quality jobs by using
Printing
the System Menu to set Draft Mode to On. The printer
automatically reduces the amount of toner by two-thirds
(and prints a draft-quality output). Draft Mode can be
selected on a per job basis from the Xerox printer drivers.
See Chapter 3: Using the Control Panel for instructions on
changing Control Panel settings.

Edge to Edge Printing

You can print PostScript LanguageLevel 3 (hereafter
referred to as PostScript) and PCL 6 Emulation (hereafter
referred to as PCL) jobs all the way to the edge of the
page. (However, there is a 4 mm border on all edges, with
all paper sizes, where print quality cannot be
guaranteed.) This feature may be selected via the Control
Panel for PCL jobs or via print drivers for both PCL and
PostScript jobs. Note that selecting this feature will cause
PCL job printing to be shifted up to the top of the page
and left to the edge of the page.
Chapter 1: Getting Started 1-9