Low Power Mode; Sleep Mode; Exiting Power Saver Mode; Power On/Off - Xerox Versant 2100 Press Quick Start Manual

Product Overview
If Low Power Mode is set to 15 minutes and Sleep Mode is set to 20 minutes, Sleep
Mode activates 5 minutes after Low Power Mode begins.

Low Power Mode

In this mode, the power to the Control Panel and fuser unit is lowered to save power.
The display goes out and the Energy Saver button on the Control Panel lights. To use
the press, select the Energy Saver button. The Energy Saver button is no longer lit,
indicating that the Energy Saver feature is canceled.

Sleep Mode

In this mode, the power is lowered more than in the Low Power mode. The display goes
out and the Energy Saver button on the Control Panel lights. To use the press, select the
Energy Saver button. The Energy Saver button is no longer lit, indicating that the Energy
Saver feature is canceled.

Exiting Power Saver Mode

The press exits Power Saver mode either by pressing the Power Saver button on the
press Control Panel or when receiving print data for an incoming job to be printed.

Power On/Off

The Power Switches

There are three power switches involved with the press:
The Breaker switch located at the rear of the press. Initially check to make sure this
switch is set to On when the press is shipped.
The Main Power switch located inside the Center Front Door. This switch is used
mainly by the Xerox Service Representative when servicing the press. In rare problem
solving cases, you may be directed to power off the press with this switch.
The Power On/Off button located on the right side of the Control Panel. This button
is the primary way for you to switch on or off the press. It is used by the operator as
workflow requires.
1-6 Xerox ® Versant 2100 Press
Quick Start Guide