Xerox DocuPrint N24 System Administrator Manual page 323

5
Use the screw driver/nut driver to
remove the two screws holding the cover
plate on the controller board as
illustrated. Set the screws and the cover
plate aside.
These screws are the same as the
screws packed with the NIC. You
will not need the cover plate when
the NIC is installed but you should
keep it in a safe place in case you
remove the card in the future.
6
Insert the NIC into the controller board
as illustrated.
Appendix C: Installing and Removing Printer Options
Xerox Network Interface Card (XNIC)
Align the 96 pin connector on the
rear underside of the card with the
96 pin receptacle in the controller
board. Align the screw receptacles
on the front edge of the NIC with
the screw slots on the front of the
controller board.
C-53