Printer Operation Problems - Xerox DocuPrint N24 System Administrator Manual

Printer Operation Problems

Printer
Operation
Problems
Table 6.1 Printer operation problems
Problem
The printer will not print
at all, or a file sent from
the client/server will not
print.
6-2 DocuPrint N24, N32, and N40 System Administrator Guide
Consult Table 6.1 for corrective actions when the printer
will not print or when the printed output is not what you
expect.
Action
1. Check with your network administrator to see that the printer is powered up,
connected to the network and that the network is operational.
2. Check Control Panel messages for "Paper Jam," "Door Open," etc.
3. If the port (parallel or network) the printer is connected to is disabled, enable
it. Check the Configuration Sheet for the port you are using to see if the Port
Enable item in the appropriate Interface Menu is set to On. If it is set to Off,
set it to On and try again.
4. If the printer has printed recently, do the following:
• Attempt to print a Configuration Sheet. If it does not print, contact your
dealer or Xerox.
• If the Configuration Sheet prints, check to see that the printer is configured
properly.
• If the printer is configured properly, check the Configuration Sheet to
confirm that the correct PDL is enabled for the port or protocol you are
using.
• If the correct PDL is enabled and the printer continues not to print, contact
your dealer or Xerox.
Table 6.1 Page 1 of 3