Replacing The Feedrolls - Xerox DocuPrint N24 System Administrator Manual

Replacing the
Feedrolls
Remove the old feedroll by
(1) pulling up on the white
tab and (2) sliding the
feedroll off the spindle.
Make sure (3) no
additional parts
come off with the
feedroll.
Install the new feedroll by
(1) pushing it onto the
spindle until (2) the white
tab clicks into place.
There are three feedrolls for each paper input tray.
Figure B.1 shows how to replace a feedroll. To locate the
feedrolls, use the procedures starting on the next page.
If you have a tabletop configuration printer (it does not have
the 2,500 Sheet Feeder installed), you only need to replace
the feedrolls for paper input Trays 1 and 2. Procedures for all
trays (standard and optional) are included in this section.
Figure B.1 Replacing a feedroll
Appendix B: Maintaining the Printer
Installing the Maintenance Kit
B-17