Power Saver Mode - Xerox 5750 System Administration Manual

1 TOOLS MODE

Power Saver Mode

Power
Mode Consumption
Ratio
Type 1 About 90%
Type 2 About 88%
Type 3 About 75%
Type 4 About 50%
1-16
The Power Saver Modes switches the printer/copier to a standby
mode by lowering the temperature of the Fuser and/or
disconnecting the power to the Control Panel, thereby reducing
power consumption.
You can select the type of Power Saver Mode and set the entry
times.
Table 5: Types of Power Saver Modes
Time to exit the
mode
About 10 seconds Disconnects the power to the Control Panel.
About 80 seconds Lower the temperature of the Fuser.
About 80 seconds Lowers the temperature of the Fuser, then
disconnects the power to the Control Panel.
About 180 seconds Disconnects the power to the Control Panel, lowers
the temperature of the Fuser, then disconnects the
power to the Fuser.
•
The power consumption ratios and exit times for each Power
Saver Mode listed in Table 4 were measured at the Mode Entry
Time: 5 minutes. If you change the Mode Entry Time, the power
consumption ratios will be different.
•
The power consumption ratio (%) of each Power Saver Mode is
to the power consumed when the Power Saver Mode feature is
not activated.
•
The exit time for the Power Saver Mode is the period it takes to
return to the Ready to Copy status.
•
The values listed in Table 4 vary depending on the operating
environments.
Remarks
5750 SYSTEM ADMINISTRATION GUIDE