Xerox DocuPrint N24 System Administrator Manual page 208

Control Panel Messages
Table 6.2 Control Panel messages and corrective actions (continued)
Message
L oa d <t ray >
< si ze > <ty pe >
6-16 DocuPrint N24, N32, and N40 System Administrator Guide
Description/Corrective Action
This message appears on two lines. the top line contains the input tray name
(e.g., Tray 1-5, Any Tray, MBF, or Envelope Feeder). The bottom line contains the
paper size (e.g., Letter (8.5 x 11), A3 (297 x 420), A4 (210 x297), etc.) and
paper type (e.g., Plain, Preprinted, Letterhead, etc.).
A tray may be out of the requested paper, or the printer is not configured for
the requested paper. The printer default settings determine whether to wait or
ignore the mismatch condition.
ACTION: If the tray is out of the requested paper, load the requested paper
(size and type) in the appropriate tray and printing continues.
If the request is for paper not loaded in the printer (e.g., the job
requests 11x17 in. paper and a tray is not configured for 11x17),
you are prompted to load the requested paper in the first tray
designated by the Tray Sequence parameter.
If you do not want to load the requested paper in the first tray in the
Tray Sequence, you can do the following:
One of the other trays can be loaded with the requested size paper
and reconfigured via the Tray Menu to match the requested paper
type.
Press Value Up
trays, displaying the size and type paper in each tray. If an alternate
paper is acceptable, press Enter
on the new paper. However, data can be lost (off the page) or not
formatted correctly when you allow a different paper size/type to be
used. Trays are searched in the order specified in the Tray Sequence
item on the Tray Menu.
or Value Down to scroll through all the
to cause printing to continue
Table 6.2 Page 12 of 21