Error Codes Summary; Power Modules; Errors Reported By The Power Module; Errors Detected By The Main Controller - Xantrex XMP 2600 Programming Manual

Xantrex multiple output power system
Table of Contents

Advertisement

Status reporting

Error Codes summary

The following is a list of error codes generated by the Power Modules and the main
controller of the XMP 2600.
Power

Errors Reported by the Power Module

Modules
1
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22

Errors Detected by the Main Controller

78
251
Errors detected during Channels Scan at Power-On
240
241
242
244
247
Errors detected during Retain or Recall
248
Main

Power Modules Communications errors

Controller
1
2
3
4
Processor Watchdog was activated.
Severe OCP error - output did not shut down.
Severe OVP error - output did not shut down.
Test error - VOUT zero test failed.
Test error - half the full scale VOUT test failed.
Test error - OVP circuit did not trip.
Test error - OVP circuit did not reset.
Output did not shut down.
Sense lines voltage drop exceeded 4V.
Current Limit was active following a three seconds period of the output being set
to zero voltage during a Retry Foldback.
Test error - output current was not zero during the output test.
Internal Communication Time Out.
Internal Communications buffer overflow.
output voltage did not drop to zero during the reprogramming period when the
relays were operated.
Internal Communication Checksum error.
Illegal command in the Internal Communications.
Internal Communications Command Error.
Internal Communications Time Out.
Internal Communications response by the Power Module was in error.
Internal Communications Time Out - Power Module not installed.
Power Module has failed its self-test.
Internal Communications response by the Power Module was in error.
Power Module did not respond with RDY.
The Power Module reported spec data did not match the internal table.
Internal Communications Time Out - Power Module not installed.
Error during channels scan (power-on).
Power Module's response to status query was in error.
Communications Interrupt Line is asserted and no Power Module responded to
scan.
Internal communication receive buffer was full.
XMP 2600 Programming Manual
Error Codes summary
rev. 1.1
77

Advertisement

Table of Contents
loading

Table of Contents