Table of Contents
Advertisement
Error Codes summary
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
RS232 Communications errors
32
33
34
GPIB Communications errors
48
49
50
Parser and Execution errors
37
39
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
Internal Communications Time Out for Power Module in channel 1.
Internal Communications Time Out for Power Module in channel 2.
Internal Communications Time Out for Power Module in channel 3.
Internal Communications Time Out for Power Module in channel 4.
Internal Communications Time Out for Power Module in channel 5.
Internal Communications Time Out for Power Module in channel 6.
Internal Communications Time Out for Power Module in channel 7.
Internal Communications Time Out for Power Module in channel 8.
Internal Communications Time Out for Power Module in channel 9.
Internal Communications Time Out for Power Module in channel 10.
Internal Communications Time Out for Power Module in channel 11.
Internal Communications Time Out for Power Module in channel 12.
Internal Communications Time Out for Power Module in channel 13.
Internal Communications Time Out for Power Module in channel 14.
Internal Communications Time Out for Power Module in channel 15.
Internal Communications Time Out for Power Module in channel 16.
Data received while DTR was off (receive buffer is full).
Transmit buffer is full.
Receive Parity Error.
Bus Error (reported by hardware).
Input Queue was full so the Bus Trigger command can not be executed.
Input Queue was full so the EOI message (set on last character which is not a LF)
can not be processed.
Communications Driver error (false End Of Command).
The Parser lost synchronization with the Input Stream (processing a non-existing
command).
a miss-placed CR in the Input Stream.
Command or Query Mnemonics are too long (more than 6 characters).
Illegal Command or Query (first character).
Illegal Command or Query.
Missing parameter (value).
Non-digit character in Numeric Parameter..
Parameter value overflow.
Parameter value is less than zero (negative).
Not a valid Channel Number (should be in the range 1 to 16).
Parameter value is out of its allowed range.
Can not display the string.
The referenced Channel has no operative Power Module installed.
The referenced Storage Area is empty - no data to recall.
Protection settings can not be programmed (Auto Protection Mode is on).
XMP 2600 Programming Manual
Status reporting
rev. 1.1
Advertisement
Table of Contents
