Chapter 5: Commands And Queries Reference; Categories; Ieee 488.1 Bus Commands; System Commands And Queries - Xantrex XMP 2600 Programming Manual

Commands and Queries Reference
5
Commands and
Queries Reference
This chapter describes all the commands and queries available when programming the
XMP 2600 from a remote controller. The chapter provides a list of Commands and
Queries grouped by category and an alphabetical reference of Commands and Queries.

Categories

This part of the commands and queries reference lists all of them divided into functional
categories.
IEEE 488.1
Device Clear .................................. Clear input and output queues. Abort Operation
BUS
Commands
Device Trigger ............................... Toggle Global Output Enable On / Off.
System
*IDN?
Commands
*OPT?
and Queries
*RCL
*RST
*SAV
*SDS
*TST?
BUFCLR
CHNL?
CLR
CONF?
DSP
This is the only way to remotely recover from a situation where the XMP
2600 Main Controller is holding off command parsing due to executing
one of the following commands: *OPC, *OPC? and *WAI. This method
is available only with GPIB.
return a string identifying the XMP 2600.
return a "1" if the XMP 2600 has a Front.
restores settings of all the Power Modules.
returns the XMP 2600 to its Power On state.
stores settings of all the Power Modules.
initialize the contents of a storage area.
initiates a self-test of the XMP 2600 main control circuits.
empty the Output Queue.
return installed Power Modules.
returns the XMP 2600 to its power on state
initiates a self-test of the XMP 2600 main control circuits.
display or remove a message on the XMP 2600 front panel display.
XMP 2600 Programming Manual
Complete Hold-Off.
rev. 1.1
Categories
35