Alphabetical Reference - Xantrex XMP 2600 Programming Manual

Alphabetical reference

Alphabetical reference
For every Command and Query, this section presents the following type of description:
[MNEMONIC]
In the descriptions that follow, Commands and Queries starting with "*" are IEEE 488.2
Common Commands and Queries.
*CLS
*ESE
*ESE?
40
{a description of the function performed by the Command or the type
of data returned by the Query}
Syntax
Parameters
Category
In the descriptions that follow, MNEMONICS are shown in Upper Case
letters. When used for programming the XMP 2600 - letter case is
ignored.
A Sequential Command is a command that cause all commands and
queries that follow it to be held off until its operation is completed. An
Overlapped Command is executed in the background while other
Commands and Queries are being parsed.
clears all Event Status Registers. Also clears the summary bits in the
Status Byte Register.
Syntax
Parameters
Category
assign new value to the Standard Event Status Enable Register. Re-
calculates <rqs> and <ist>.
Syntax
Parameters
Category
return the value of the Standard Event Status Enable Register. The
value returned is a decimal number in the range 0 to 255 representing
the bits of the Register.
Syntax
Parameters
Category
XMP 2600 Programming Manual
Commands and Queries Reference
<Command or Query Syntax> not including
terminators.
{a list and short description of the parameters to the
Command or Query}
[functional group]
*CLS
none
Status
*ESE <int>
the value to be assigned to the Register - a decimal
number in the range 0 to 255 representing bits in the
Register.
Status
*ESE?
none
Status
rev. 1.1
Type: {Sequential or
Overlapped}
Type: Sequential
Type: Sequential
Type: Sequential