Xantrex XMP 2600 Programming Manual page 70

Commands and Queries Reference
PROT
PROT?
PSR?
PWR?
RAMP
set-up the Protection Mode of the Power Module.
Syntax
Parameters
Category
return the current Protection Mode of the XMP 2600.
Syntax
Parameters
Category
return the value of the Primary Status Register. The value returned is a
decimal number in the range 0 to 255 representing the bits of the
Register.
Syntax
Parameters
Category
return the value of the Power Warning Threshold of the XMP 2600
master mainframe. For the XMP 2600 this value is 2400.
Syntax
Parameters
Category
program the Power Module's Ramp Duration.
Syntax
Parameters
Category
XMP 2600 Programming Manual
PROT <ch>,<int>
the number of the Power Module to be programmed.
the desired Protection Mode: a value of "0" means
Manual Protection Mode - in this mode the OVP and
OCP thresholds are programmed by the user. A
value of "1" means Automatic Protection Mode - the
OVP and OCP thresholds are set, automatically, by
the XMP 2600 as 10% to 20% above the SET
values. If changing from Manual to Automatic mode
then new OVP and OCP thresholds are calculated.
Protection
PROT? <ch>
the number of the channel to be queried.
Protection
PSR?
none
Status
PWR?
none
System
RAMP <ch>,<ramp_duration>
the number of the Power Module to be programmed.
the Ramp Duration in units of mili-seconds. The
XMP 2600 Ramp Duration resolution is 6mS, so the
programmed value will be set internally to a
multiplication of 6. The general format for the Ramp
Duration is: sss:nnn where sss=seconds and
nnn=mili-seconds. The maximal duration is 393:210.
Duration can be programmed in units of mili-
seconds (e.g. "4032" = 004:032) or seconds (e.g.
"100:" = 140:000).
Settings
rev. 1.1
Alphabetical reference
Type: Overlapped
Type: Sequential
Type: Sequential
Type: Sequential
Type: Sequential
57