Xantrex XMP 2600 Programming Manual page 78

Commands and Queries Reference
TRIGER
VALL?
VHIGH
VHIGH?
VLIM
send a trigger to the Power Module.
Syntax
Parameters
Category
return load voltage measurements of all installed Power Modules. The
response is a series of values - one for each installed Power Module,
separated with ",", starting with the lower numbered module. If auto-
polarity is enabled, negative output values will be preceded with a
minus sigh.
Syntax
Parameters
Category
program the upper window warning level for the load voltage of the
Power Module.
Syntax
Parameters
Category
return the current settings for the upper window warning level of the
load voltage of the Power Module. The response is a <value>.
Syntax
Parameters
Category
program an upper limit on subsequent programming of voltage
settings for the Power Module.
Syntax
Parameters
Category
XMP 2600 Programming Manual
TRIGER <ch>
the number of the Power Module to send the trigger
to.
Trigger and Sync
VALL?
none
Read-back
VHIGH <ch>,<value>
the number of the Power Module to be programmed.
the value to be set as the upper window warning
level for the load voltage. The upper limit of the
programmed value is VMAX. The lower limit of the
programmed value is VSET.
Warnings
VHIGH? <ch>
the number of the channel to be queried.
warnings
VLIM <ch>,<value>
the number of the Power Module to be programmed.
the value to become the new upper limit for VSET
programming. The upper value of the programmed
value is VMAX.
Settings
rev. 1.1
Alphabetical reference
Type: Overlapped
Type: Sequential
Type: Sequential
Type: Sequential
Type: Sequential
65