Xantrex XMP 2600 Programming Manual page 55

Alphabetical reference
*PRE
*PRE?
*PSC
*PSC?
*RCL
*RST
42
assign new value to the Parallel Poll Enable Register. Re-calculates
<ist>.
Syntax
Parameters
Category
return the value of the Parallel Poll Enable Register. The value
returned is a decimal number in the range 0 to 255 representing the
bits of the Register.
Syntax
Parameters
Category
controls whether or not the XMP 2600 will clear all the Event Enable
Registers and the SRQ and Parallel Poll Enable Registers at Power
On.
Syntax
Parameters
Category
return the value of the Power On Status Clear Enable Flag: "0"
(disabled) or "1" (enabled).
Syntax
Parameters
Category
restores settings of all the Power Modules (same as RCL command).
Syntax
Parameters
Category
returns the XMP 2600 to its Power On state: send a Fault Reset
Command to all faulty Power Modules, if the Primary was shut down
then try to revive it, Initialize or Retain Power Modules Settings,
return the Front Panel Display to Normal Status Mode. Does not clear
the status structures (except for the Primary status).
Syntax
Parameters
Category
XMP 2600 Programming Manual
Commands and Queries Reference
*PRE <int>
the value to be assigned to the Register - a decimal
number in the range 0 to 255 representing bits in the
Register.
Status
*PRE?
none
Status
*PSC <int>
a value of 0 disables the XMP 2600 from clearing
the Registers at Power On. Any other value (in the
range 1 to 255) enables clearing of the Register.
Status
*PSC?
none
Status
*RCL <int>
a decimal number in the range 0 to 9 specifying the
storage number the XMP 2600 will restore the
settings from.
System
*RST
none
System
rev. 1.1
Type: Sequential
Type: Sequential
Type: Sequential
Type: Sequential
Type: Overlapped
Type: Sequential