Xantrex XMP 2600 Programming Manual page 66

Commands and Queries Reference
MON
MON?
OCRST
OCSET
OCSET?
OPT?
change the operating mode of the RS232 serial communication
interface into or out of Monitor Mode.
Syntax
Parameters
Category
return the current state of the Monitor Mode. A value of "0" means
that Monitor Mode is off. A value of "1" indicate that the Monitor
Mode is on.
Syntax
Parameters
Category
see OVRST
program the Power Module's Over Current Protection.
Syntax
Parameters
Category
return the current programmed value of the Power Module's OCP
threshold. The result is a <value>.
Syntax:
Parameters
Category
return the Options Byte of the Power Module. The result is a decimal
value in the range 0 to 255 representing bits of the Options Byte.
For now only three bits have meaning:
Bit 4 is cleared when the Power Module has the output
disconnect relay option.
Bit 5 is cleared if the Power Module has the polarity reversal
relay option.
Bit 3 is set if this module has power monitoring logic (e.g. 1/8
36V/40A module)
Syntax
Parameters
Category
XMP 2600 Programming Manual
MON <int>
the requested mode of operation for the RS232 serial
interface. A value of "0" will turn Monitor Mode
off. A value of "1" will turn it on.
System
MON?
none
System
OCSET <ch>,<value>
the number of the Power Module to be programmed.
the value to be assigned to the OCP threshold. A
value can only be programmed when PROT mode is
Manual. The upper limit of the Programmed value is
IMAX + 1. The lower limit of the programmed
value is ISET.
Protection
OCSET? <ch>
the number of the channel to be queried.
Protection
OPT? <ch>
the number of the channel to be queried.
Status
rev. 1.1
Alphabetical reference
Type: Overlapped
Type: Sequential
Type: Sequential
Type: Sequentail
Type: Sequential
wide
53