Xantrex XMP 2600 Programming Manual page 54

Commands and Queries Reference
*ESR?
*IDN?
*IST?
*OPC
*OPC?
*OPT?
return the value of the Standard Event Status Register. The value
returned is a decimal number in the range 0 to 255 representing the
bits of the Register. The register is cleared. <rqs> and <ist> are re-
calculated.
Syntax
Parameters
Category
return a string identifying the XMP 2600. The returned string is:
'TESTORNICS,TESTORN 2400,0,n.nn' where n.nn is the firmware
revision code.
Syntax
Parameters
Category
return the current value of the Individual Status bit as defined by IEEE
488.1.
Syntax
Parameters
Category
causes the XMP 2600 to suspend further parsing of commands and
queries until all pending operations have finished. Then, the Operation
Complete (opc) event bit of the Standard Event Status Register will be
set.
Syntax
Parameters
Category
causes the XMP 2600 to suspend command parsing until all pending
operations have been finished. Then, the XMP 2600 response to the
Query with: "1".
Syntax
Parameters
Category
return a "1" if the XMP 2600 has a Front Panel or "0" if no Front
Panel exists or connected.
Syntax
Parameters
Category
XMP 2600 Programming Manual
*ESE?
none
Status
*IDN?
none
System
*IST?
none
Status
*OPC
none
Synchronization
*OPC?
none
Synchronization
*OPT?
none
System
rev. 1.1
Alphabetical reference
Type: Sequential
Type: Sequential
Type: Sequential
Type: Sequential
Type: Sequential
Type: Sequential
41