5.3.6.1.1 Approach End Stop Value; Figure 15: Approach End Stop Value; Table 29: Approach End Stop Value - WAGO 750-632 Manual

WAGO-I/O-SYSTEM 750
750-632 Proportional Valve Module

5.3.6.1.1 Approach End Stop Value

Figure 15: Approach End Stop Value

Table 29: Approach End Stop Value

No. Event
Set SPL_EN to "1"
1
2 Change setpoint value
Set DI to "1".
3
4 Set SPL_EN to "0"
Set SPL_EN to "1"
5
6 Set DI to "1".
Manual
Version 1.3.0, valid from FW/HW-Version 01/01
Description/Behavior
"Automatic mode" is activated.
Ramp starts.
Rising ramp stops. Actual value drops until the
end stop value is reached. The actual value is
then frozen.
The actual value is still frozen.
Ramp increases.
The positive edge of DI again lead causes the
rising ramp to stop. Actual value drops until
the end stop value is reached. The actual value
is then frozen.
Function Description 43