Table; Table 88: Parameter, Table 32 (Module Monitoring) - WAGO 750-632 Manual

WAGO-I/O-SYSTEM 750
750-632 Proportional Valve Module
Table 87: Parameters, Table 33 (DI1)
Register Name,
11.4.1.5 Table 40 (Additional Module Parameters

Table 88: Parameter, Table 32 (Module Monitoring)

Register Name,
0
Manual
Version 1.3.0, valid from FW/HW-Version 01/01
Bits
Type Explanation
Bits
Type Explanation
PWR_EN_USE 0
_STOPRAMP,
UINT16
Value/Range Description
(Default)
3 HOLD Valve 1
Maintains current setpoint
value.
Note:
This function is state-controlled:
• If the input is activated, the
"HOLD" function is also
activated. The setpoint
value cannot be
approached.
• If the input is deactivated,
the "HOLD" function is
also deactivated. The
current setpoint value is
approached.
4
Jog + Valve 1
OR function using control bit 7
for Valve 1
5 Jog - Valve 1
OR function using control bit 6
for Valve 1
6 Jog + Valve 2
OR function using control bit 7
for Valve 2
7
Jog - Valve 2
OR function using control bit 6
for Valve 2
8 ... 255 (reserved)
Value/Range Description
(Default)
0 ... 1 Use stop ramp to disable the
(Default: 0) output stages. Use stop ramp to
approach the substitute value.
Appendix 121