Power Supply For Marine Applications; Figure 34: Power Supply, Marine Applications; Table 51: Legend For Figure "Power Supply, Marine Applications - WAGO 750-632 Manual

72 Connect Devices
Pos : 90 /Serie 750 ( WAGO-I/O-SYST EM)/Ans chli eßen/Eins peisekonz epte/Ei nspeis ung 750- 632 bei Ei nsatz i m Sc hiffs bereic h - Ü bersc hrift 2 und Inhalt @ 24\mod_1446133712717_21.doc x @ 194648 @ 2 @ 1
8.2

Power Supply for Marine Applications

Use a separate power supply when operating the module in marine
applications!
When using the 750-632 module in marine applications, the requirements
described below must be respected. Non-compliance with these requirements may
lead to malfunctions due to conductive interference emission.
The system power supply must be filtered in the bus node. Therefore, the 750-626
module must be used for system power supply.
An external power supply unit must be used when supplying the 750-632 module
with field-side power. The power supply unit must meet EMC 1 or EMC 2
requirements per IACS E10. This power supply unit can be used to supply several
750-632 modules – but no other components or devices.
The field supply must be filtered in the bus node. Therefore, the 750-632 module
shall only be connected to the right side of the 750-624 Filter Module or to other
750-632 modules. Only a bus module without power jumper contacts (e.g.,
supply, filter or end module) shall be connected to the right side of the 750-632
module(s).
Figure 34: Power Supply, Marine
Applications
Pos : 91 /D okumentation allgemei n/Glieder ungs elemente/---Seitenwechs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
750-632 Proportional Valve Module
Table 51: Legend for Figure "Power Supply, Marine
Applications"
Pos. Beschreibung
1 750-626 – Power supply and filter
2 Bus power supply unit, as part of the head
station or as separate bus module (e.g.,
750-613)
3 System supply U
via bus contacts)
4 Field supply U
via power jumper contacts)
5 750-624 – Filter
6 Power supply (e.g., via 750-602)
7 External power supply unit for 24 VDC
Version 1.3.0, valid from FW/HW-Version 01/01
WAGO-I/O-SYSTEM 750
with 5 VDC (internal,
S
with 24 VDC (internal,
F
Manual