Device Description - WAGO 750-632 Manual

16

Device Description

Pos : 20 /All e Seri en (Allgemei ne Module)/Ü berschriften/N eue Ü berschriften/Ebene 1Ger ätebesc hrei bung - Ü berschrift 1 @ 3\mod_1233756084656_21.doc x @ 27096 @ 1 @ 1
4 Device Description
Pos : 21.1 /Serie 750 (WAGO-I/O-SYST EM)/Ger ätebesc hrei bung/Ei nlei tung/Anwendung/SO/Anwendung 750-0632 @ 14\mod_1360942636601_21.doc x @ 112047 @ @ 1
The I/O module serves to control proportional valves. The I/O module has two
outputs with switchable dithering that can be current-controlled via pulse width
modulation. A unidirectionally functioning coil or a bidirectionally functioning
coil for a valve can be connected at each output. The I/O module can be set to the
valve characteristics using parameters. Thus, for example, operating ranges or
valve characteristic curves can be individually set.
In addition, the I/O module offers an adjustable setpoint ramp function. It is
therefore possible to parameterize the characteristics of the rising or falling ramps.
It is a given that the I/O module has two digital inputs that can, for example,
monitor threshold value switches.
Pos : 21.2 /Serie 750 (WAGO-I/O-SYST EM)/Ger ätebesc hrei bung/Ei nlei tung/I/O-Besc hrei bung/SO/I/I/O-Besc hrei bung 750-0632 @ 16\mod_1372942241833_21.doc x @ 125532 @ @ 1
The I/O module can be configured and parameterized via:
• WAGO-I/O-CHECK or
• Function blocks
Pos : 22 /D okumentation allgemei n/Glieder ungs elemente/---Seitenwechs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
WAGO-I/O-SYSTEM 750
750-632 Proportional Valve Module
Version 1.3.0, valid from FW/HW-Version 01/01
Manual