LCB–Lens Motor Calibration
Calibrates all of the lens motors.
This command is only enabled when the projector is on.
Commands
Command
Description
LCB 1
Runs calibration on all lens motors.
LCB+HOME
Moves all lens motors back to the center flag for each axis and sets
their respective positions to 0.
LCB+ZOOM 1
Calibrates the zoom motor.
Examples
Start calibration:
(LCB 1)
Move the lens back to the home position:
(LCB+HOME)
LHO–Lens Horizontal Position Adjustment
Sets the lens horizontal location to an absolute position.
This command is only available when the projector is on.
Commands
Command
Description
LHO?m
Returns the minimum and maximum range of the zoom axis
based on the last lens calibration performed. The returned
range is persistent across AC cycles. (Read-only)
LHO
Adjusts the horizontal location of the lens to the specified
<position>
position. The position is persistent across AC cycles.
Examples
Move the lens to position 500 on the horizontal axis:
(LHO 500)
Boxer 30 Technical Reference–Serial API Commands
020-102096-08 Rev. 1 (08-2020)
Copyright
©
2020 Christie Digital Systems USA, Inc. All rights reserved.
Serial API commands
Values
1
—
1
Values
—
position = Numeric value subject
to the range returned in LHO?m
39