Ken-Keypad Enable; Lcb-Lens Motor Calibration - Christie Crimson Technical Reference

KEN–Keypad Enable
Enables or disables the IR or wired keypad sensors.
Commands
Command Description
KEN+FRNT <0 | 1> Enables or disables the IR keypad sensor.
(Saved value)
KEN+HDBT <0 | 1> Enables IR over HDBaseT. (Saved value)
KEN+REAR <0 | 1> Enables or disables the rear IR keypad
sensor. (Saved value)
KEN+WIRE? Returns the current wired jack enabled
state. (Read-only)
KEN+WIRE <0 | 1> Enables or disables the wired keypad sensor.
(Saved value)
Examples
Get the current wired jack enabled state:
(KEN+WIRE?)
Disable the front IR sensor:
(KEN+FRNT 0)
Disable the rear IR sensor:
(KEN+REAR 1)
LCB–Lens Motor Calibration
Calibrates all of the lens motors.
This command is only enabled when the projector is on.
Commands
Command Description
LCB 1 Runs calibration on all lens motors.
LCB+HOME Moves all lens motors back to the center flag for each
axis and sets their respective positions to 0.
Crimson and Crimson Mirage Technical Reference–Serial Commands
020-102660-01 Rev. 1 (07-2018)
Copyright 2018 Christie Digital Systems USA, Inc. All rights reserved.
©
Serial API commands
Values
0 = Disables the front IR keypad sensor
1 = Enables the front IR keypad sensor
(Default)
0 = Disables IR over HDBaseT (Default)
1 = Enables IR over HDBaseT
0 = Disables the rear IR keypad sensor
1 = Enables the rear IR keypad sensor
(Default)
—
0 = Disables the wired keypad jack
1 = Enables the wired keypad jack (Default)
Values
1
—
34