Christie Boxer 30 Technical Reference page 48

Command
NET+DGRP "<group>"
NET+DHCP 1
NET+ETH0?
NET+GATE?
NET+HOST "<name>"
NET+MAC0?
NET+PORT?
NET+SUB0?
NET+SWIT <0 | 1 | 2>
Examples
Set the static IP address to 192.168.1.100, with a netmask of 255.255.255.0, and no gateway:
(NET "192.168.1.100" "255.255.255.0")
Turn on DHCP support:
(NET+DHCP 1)
Boxer 30 Technical Reference–Serial API Commands
020-102096-08 Rev. 1 (08-2020)
Copyright © 2020 Christie Digital Systems USA, Inc. All rights reserved.
Description
Sets the device group name for the projector. (Saved
value)
This can help simplify broadcast searching by
organizing projectors into groups, particularly if a large
number of projectors are on the same local network.
Enables DHCP. To turn off DHCP support, switch to a
static IP by using the base command. (Saved value)
Returns the projector IP address. (Read-only)
Returns the projector gateway address. (Read-only)
Sets the name for the projector. (Saved value)
With this set, devices on the same network subnet as
the projector can connect to it using the name:
<name>.local.
Returns the MAC address of the Ethernet port. (Read-
only)
Returns the TCP port used for the Christie serial
protocol over Ethernet. (Read-only)
Returns the projector netmask. (Read-only)
Sets the internal network switching mode.
Serial API commands
Values
group = Group name for
the projector
1
—
—
name = Name for the
projector
—
1024 to 49151 (with some
exceptions)
3003 = Reserved on the
projector and cannot be
used for the Christie serial
protocol
—
0 = Split (Default)
1 = All ports joined
2 = HDBaseT joined with
Ethernet (for network
loop-through)
48