Cycle997 Measuring Cycle Parameters - Siemens SINUMERIK 840D sl Programming Manual

No Screen Cycle pa‐
. form param‐ rameters
eters
19 TMV
S_TMV
20 FW
S_K
21
S_EVNUM
22
S_MCBIT
23
_DMODE
24
_AMODE
All default values = 0 or marked as the range of values a to b
0)
Display depends on the general SD 54760 $SNS_MEA_FUNCTION_MASK_PIECE
1)
Only for offset in tool, otherwise parameter = ""
2)
Only for offset in tool and dimensional tolerance "Yes", otherwise parameter = 0
3)
Only if the "Setup additive offset" function has been set-up in the general MD 18108 $MN_MM_NUM_SUMCORR .
4)
If WO "fine" has not been set up in MDs, correction is according to WO "coarse".
5)
Empirical averaging only possible for tool offset
6)
Value range for empirical mean value memory:
1 to 20 numbers (n) of the empirical value memory, see channel-specific SD 55623 $SCS_MEA_EMPIRIC_VALUE[n-1]
10000 to 200000 numbers (n) of the mean value memory, see channel-specific SD 55625
$SCS_MEA_AVERAGE_VALUE[n-1]
Value range of starting angle -360 to +360 degrees
7)
Value range of incremental angle >0 to ≤90 degrees for four measuring points or >0 to ≤120 degrees for three measuring
8)
points.
4.1.10

CYCLE997 measuring cycle parameters

PROC CYCLE997 (INT S_MVAR,INT S_KNUM,INT S_PRNUM,REAL S_SETV,REAL S_FA,REAL S_TSA,REAL
S_STA1,REAL S_INCA,REAL S_SETV0,REAL S_SETV1,REAL S_SETV2,REAL S_SETV3,REAL S_SETV4,REAL
S_SETV5,REAL S_SETV6,REAL S_SETV7,REAL S_SETV8,REAL S_TNVL,INT S_NMSP,INT S_MCBIT,INT
_DMODE,INT _AMODE)
Measuring cycles
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Meaning
Offset range for averaging
Weighting factor for averaging
Date set, empirical value memory
Reserved
Display mode
Val‐ UNITS: Machining plane G17/G18/G19
ues:
0 = Compatibility, the plane active before the cycle call remains active
1 = G17 (only active in the cycle)
2 = G18 (only active in the cycle)
3 = G19 (only active in the cycle)
Alternative mode
Val‐ UNITS: Dimensional tolerance yes/no
ues:
0 = No
1 = Yes
4.1 Overview of measuring cycle parameters
1)
1)
1), 6)
Parameter lists
325