Edge Distance - Align Edge (Cycle998) - Siemens SINUMERIK 840D sl Programming Manual

Measuring variants
3.3 Measure workpiece (milling)
Parameters
_OVR [2]
_OVR [3]
_OVR [4]
_OVR [5]
_OVR [6]
_OVR [7]
_OVR [16]
_OVR [17]
_OVR [18]
_OVR [19]
_OVR [21]
_OVI [0]
_OVI [2]
_OVI [3]
_OVS_TNAME
For workpiece measurement with tool offset or correction in the work offset, additional
parameters are displayed, see Additional result parameters (Page 342).
3.3.8

Edge distance - align edge (CYCLE998)

Function
The workpiece lies in any direction, i.e. not parallel to the workpiece coordinate system (WCS)
on the work table. By measuring two points on the workpiece reference edge that you have
selected, you determine the angle to the active coordinate system. You can correct this angle
as a rotation either in a geometry axis or as translatory offset in a rotary axis (rotary table) in
any WO or in the active WO.
Note
Maximum measured angle
Using the "Align edge" measuring variant, a maximum angle of +/- 45 degrees can be
measured.
134
Description
Setpoint in 2nd axis of the plane → only for S_MA=2
Setpoint in 3rd axis of the plane → only for S_MA=3
Actual value for measuring axis
Actual value in 1st axis of the plane → only for S_MA=1
Actual value in 2nd axis of the plane → only for S_MA=2
Actual value in 3rd axis of the plane → only for S_MA=3
Difference for measuring axis
Difference in 1st axis of the plane → only for S_MA=1
Difference in 2nd axis of the plane → only for S_MA=2
Difference in 3rd axis of the plane → only for S_MA=3
Mean value
D number or WO number
Measuring cycle number
Measuring variant
Tool name
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Unit
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
-
-
-
-
Measuring cycles