Result Parameters - Siemens SINUMERIK 840D sl Programming Manual

Measuring variants
3.6 Measure tool (milling)
Parameter
ΔV
DFA
TSA
The "Individually check teeth" function is displayed if bit 10 is set in the general SD 54762
1)
$SNS_MEA_FUNCTIONS_MASK_TOOL .
Measuring variant, turning on a milling machine (only 840D sl)
Procedure
The part program or ShopTurn program to be edited has been created and you are in the editor.
Parameter
ShopTurn program
Parameter Description
T Name of the probe
D Cutting edge number (1 - 9)
Calibration data set (1 - 6)
F Calibration and measuring fee‐
drate
X Start point X of the measurement mm
Y Start point Y of the measurement mm
Z Start point Z of the measurement mm
3.6.3.7

Result parameters

List of the result parameters
The measuring version "Measure milling tool" or "Measure drill" provides the following result
parameters:
Table 3-46
Parameter
_OVR [8]
_OVR [9]
_OVR [10]
298
Description
Offset correction (only for tool offset "Yes" or "Automatic")
Measurement path
Safe area for the measurement result
1. Press the "Meas. workp." softkey.
2. Press the "Milling tool" softkey.
"Measure tool" result parameters
Description
Actual value of length L1
Difference of length L1
edge
3)
Actual value of radius R
edge
4)
Unit
-
-
-
mm/min
/ length of the longest cutting edge
1)
/ difference of length of the longest cutting
1)
/ actual value of radius of the longest cutting
2),
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Unit
mm
mm
mm
Unit
mm
3)
mm
mm
Measuring cycles