Siemens SINUMERIK 840D sl Programming Manual page 331

Table 4-12 CYCLE996 call parameters
No Screen Cycle pa‐
. form param‐ rameters
eters
1
S_MVAR
2
S_TC
3 Icon+
S_PRNUM
number
Measuring cycles
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
1)
Meaning
Measurement version (default=1)
Val‐ UNITS: Measuring sequence
ues:
0 = Calculate kinematics (selection with: Result display, protocol, change of the
swivel data sets, where relevant with operator acknowledgment), see _AMODE
1 = 1st measurement
2 = 2nd measurement
3 = 3rd measurement
TENS: Reserved
0 = 0
HUNDREDS: Measurement version for 1st to 3rd measurement
0 = Measurement of the calibration ball paraxial
1 = Measurement of the calibration sphere at an angle and no spindle correction
2 = Measurement of the calibration sphere and correction of the spindle in the
switching direction of the probe
3 = Paraxial measurement, with starting angle
4 = Paraxial measurement, with starting angle, tracking spindle in the switching
direction of the probe
THOUSANDS: Calculate correction target for kinematics
0 = measuring only. Swivel data sets are calculated, but remain unchanged
1 = calculate swivel data set. Swivel data sets are, if necessary, changed after
acknowledgment by the operator
TEN THOUSANDS: Measuring axis (rotary axis 1 or 2) or vector chain open or
closed for calculate kinematics
0 = Vector chain closed (only for calculate kinematics)
1 = Rotary axis 1 (only for 1st to 3rd measurement)
2 = rotary axis 2 (only for the 1st to 3rd measurement)
3 = vector chain open (only for calculate kinematics)
HUNDRED THOUSANDS: Normalizing of rotary axis 1 for calculate kinematics
0 = no scaling rotary axis 1
1 = scaling in the direction of the 1st axis of the plane (for G17 X)
2 = scaling in the direction of the 2nd axis of the plane (for G17 Y)
3 = scaling in the direction of the 3rd axis of the plane (for G17 Z)
ONE MILLION: Normalizing of rotary axis 2 for calculate kinematics
0 = no scaling rotary axis 2
1 = scaling in the direction of the 1st axis of the plane (for G17 X)
2 = scaling in the direction of the 2nd axis of the plane (for G17 Y)
3 = scaling in the direction of the 3rd axis of the plane (for G17 Z)
TEN MILLION: Log file
0 = no protocol file
1 = protocol file with the calculated vectors (tool carrier) and the 1st dynamic 5-
axis transformation (TRAORI(1)), if set-up in MDs.
Number of the swivel data record (tool carrier)
Number of the field of the probe parameters (not probe number)
(default=1)
4.1 Overview of measuring cycle parameters
3)
8)
8)
4)
Parameter lists
3)
4)
5)
5)
331