Siemens SINUMERIK 840D sl Programming Manual page 319

No. Screen Cycle pa‐
form param‐ rameters
eters
14 X
S_MA
15 Measure‐
S_NMSP
ments
16 TR
S_TNAME
17 DL
S_DLNUM
18 TZL
S_TZL
19 DIF
S_TDIF
20 TUL
S_TUL
21 TLL
S_TLL
22 TMV
S_TMV
23 FW
S_K
24
S_EVNUM
25
S_MCBIT
26
_DMODE
27
_AMODE
All default values = 0 or marked as the range of values a to b
1)
Display depends on the general SD 54760 $SNS_MEA_FUNCTION_MASK_PIECE
2)
Only for offset in tool, otherwise parameter = ""
3)
Only for offset in tool and dimensional tolerance "Yes", otherwise parameter = 0
4)
Only if the "Setup additive offset" function has been set-up in the general MD 18108 $MN_MM_NUM_SUMCORR . In
5)
addition, in the general MD 18080 $MN_MM_TOOL_MANAGEMENT_MASK , bit8 must be set to 1.
If WO "fine" has not been set up in MDs, correction is according to WO "coarse"
6)
Diameter or width of the protection zone within a hole or groove
7)
Diameter or width of the protection zone outside of a spigot or rib
Empirical averaging possible for tool offset
8)
Value range for empirical mean value memory:
1 to 20 numbers (n) of the empirical value memory, see channel-specific SD 55623 $SCS_MEA_EMPIRIC_VALUE[n-1]
10000 to 200000 numbers (n) of the mean value memory, see channel-specific SD 55625
$SCS_MEA_AVERAGE_VALUE[n-1]
Measuring cycles
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Meaning
Number of the measuring axis
Val‐ 1 = 1st axis of the plane (for G17 X)
ues: 2 = 2nd axis of the plane (for G17 Y)
Number of measurements at the same location
Tool name
2)
Setup additive offset DL number
Work offset
2), 4)
Dimensional difference check
Upper tolerance limit (incremental to the setpoint)
Lower tolerance limit (incremental to the setpoint)
Offset range for averaging
Weighting factor for averaging
Data set, empirical mean value memory
Reserved
Display mode
Val‐ UNITS: Machining plane G17/G18/G19
ues:
0 = Compatibility, the plane active before the cycle call remains active
1 = G17 (only active in the cycle)
2 = G18 (only active in the cycle)
3 = G19 (only active in the cycle)
Alternative mode
Val‐ UNITS: Dimensional tolerance yes/no
ues:
0 = No
1 = Yes
4.1 Overview of measuring cycle parameters
(only for measurement of groove or rib)
7)
(value range 1 to 9)
2)
5)
2), 4)
4)
4)
2)
2)
2), 8)
Parameter lists
319