Siemens SINUMERIK 840D sl Programming Manual page 155

Parameter
G code program
Parameter Description
PL Measuring plane (G17 - G19) -
Calibration data set (1 - 40)
Parameter Description
Correction target
● Measuring only (no offset)
● Work offset (save measured values in a settable WO)
Position Type of corner:
Outside corner
Position of the cor‐
●
ner
●
●
●
X0 Setpoint X of the corner (for measuring plane G17)
Y0 Setpoint Y of the corner (for measuring plane G17)
XP Pole (for measuring plane G17)
YP Pole (for measuring plane G17)
α0 Angle specification with regard to the angle reference edge to be measured and the 1st
geometry axis of the active plane in the machine coordinate system (MCS).
This allows the axes to be traversed to the angle parallel to the edges.
L1 Distance between the pole and measuring point P1 in the direction of the 1st axis of the
plane (for G17, X)
L2 Distance between the pole and measuring point P2 in the direction of the 1st axis of the
plane
L3 Distance between the pole and measuring point P3 in the direction of the 2nd axis of the
plane (for G17, Y)
Protection zone Use protection zone
● Yes
● No
DZ Infeed distance at measuring height (only for protection zone "Yes")
DFA Measurement path
TSA Safe area for the measurement result
Other parameters and correction targets can be set in the general SD 54760 $SNS_MEA_FUNCTION_MASK_PIECE .
1)
Measuring cycles
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
ShopMill program
Unit Parameter
T
- D
X
Y
Z
Machine manufacturer
Please observe the information provided by the machine manufacturer.
3.3 Measure workpiece (milling)
Description
Name of the probe
Cutting edge number (1 - 9)
Calibration data set (1 - 40)
Start point X of the measurement
Start point Y of the measurement
Start point Z of the measurement
1)
Inside corner
●
●
●
●
Measuring variants
Unit
-
-
-
mm
mm
mm
Unit
-
-
-
-
mm
mm
mm
mm
Degrees
mm
mm
mm
-
mm
mm
mm
155