Siemens SINUMERIK 840D sl Programming Manual page 118

Measuring variants
3.3 Measure workpiece (milling)
Position after the end of the measuring cycle
The probe ball center is located in front of the reference edge by the distance of the measuring
path.
Procedure
The part program or ShopMill program to be processed has been created and you are in the
editor.
Parameter
G code program
Parameter Description
PL Measuring plane (G17 - G19)
Calibration data set (1 - 40)
F Calibration and measuring fee‐
drate
Parameter Description
Calibration directions ● 1: Calibration in one direction
● 2: Calibrations in opposite directions
Determine position
● Yes (determine position deviation of the probe)
deviation
● No (do not determine position deviation of the probe)
Measuring axis
● X (for G17)
● Y (for G17 and G19)
● Z (for G19)
118
1. Press the "Meas. workpiece" softkey.
2. Press the "Calibrate probe" softkey.
3. Press the "Radius at edge" softkey.
The input window "Calibrate: Radius at edge" opens.
ShopMill program
Unit Parameter
- T
- D
Distance/
min
F
X
Y
Z
Description
Name of the probe
Cutting edge number (1 - 9)
Calibration data set (1 - 40)
Calibration and measuring fee‐
drate
Start point X of the measure‐
ment
Start point Y of the measure‐
ment
Start point Z of the measure‐
ment
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Unit
-
-
-
mm/min
mm
mm
mm
Unit
-
-
-
Measuring cycles