Measuring Cycle Support In The G Code Editor - Siemens SINUMERIK 840D sl Commissioning Manual

Functions

3.17 Measuring cycle support in the G code editor

3.17 Measuring cycle support in the G code editor
General
In HMI-Embedded, you can integrate screen forms in the G code editor that provide support
when programming measuring cycles. These cycles can then be recompiled automatically.
The "measuring cycles" function is a software option with order no. 6FC520-0BX00-0AB0.
For further information about measuring cycle support, please refer to:
References: Program Manual Measuring Cycles
Procedure
Proceed as follows when installing the function:
1. Import file "common.com" to the following directory on the CompactFlash card:
/user/sinumerik/hmi/cfg
.
2. Open the file in the editor.
3. Remove the semicolon ";" in front of the following lines:
4. Remove the semicolon ";" in front of the following line:
You can change other properties of the measuring cycle support from the user interface of
HMI-Embedded:
In the "Commissioning" operating area, press the expansion key ">" and the softkey
"Measuring cycles".
46
– ;SC326 = AEDITOR.COM ;Turning measuring cycles (horizontal softkey 6 on the
extended softkey bar in the G code editor)
– ;SC327 = AEDITOR.COM ;Milling measuring cycles (horizontal softkey 7 on the
extended softkey bar in the G code editor).
This is how you establish the connection between the softkeys used to call measuring-
cycle support and the configuration file for these support screens.
– ;SC617 = STARTUP.COM ;Commissioning operating area (horizontal softkey 7 on the
extended softkey bar in the G code editor).
This is how you change the properties of the measuring-cycle support in the
Commissioning operating area.
Commissioning HMI-Embedded (IM2)
Commissioning Manual, 01/2008, 6FC5397-8CP10-1BA0