Siemens SINUMERIK 840D sl Programming Manual page 318

Parameter lists
4.1 Overview of measuring cycle parameters
No. Screen Cycle pa‐
form param‐ rameters
eters
3 Selection
S_KNUM1
4 Icon+
S_PRNUM
number
5 X0
S_SETV
6 X0
S_SETV0
7 Y0
S_SETV1
8 DFA
S_FA
9 TSA
S_TSA
10 α 0
S_STA1
11 DZ
S_ID
12 X1
S_SZA
13 Y1
S_SZO
318
Meaning
Correction in tool offset
2)
Val‐ UNITS:
ues:
TENS:
HUNDREDS:
0 = No correction
1 to max. 999 D numbers (cutting edge numbers) for tool offset; for additive and
setup offset, see also S_DLNUM
THOUSANDS: 0 or unique D numbers
TEN THOUSANDS: 0 or unique D numbers
1 to max. 32000 if unique D numbers in MDs have been set up
HUNDRED THOUSANDS: Tool offset
0 = No specification (offset tool radius)
1 = Offset of length L1
2 = Offset of length L2
3 = Offset of length L3
4 = Radius offset
ONE MILLION: Tool offset
0 = No specification (offset of the tool radius wear)
1 = Tool offset, additive offset (AO)
Tool offset value is added to the existing AO
2 = Tool offset, setup offset (SO)
SO (new) = SO (old) + AO (old) offset value, AO (new) = 0
3 = Tool offset, setup offset (SO)
Tool offset value is added to the existing SO
4 = Tool offset, geometry
TEN MILLION: Tool offset
0 = No specification (offset in tool geometry normal, not inverted)
1 = Offset inverted
Number of the field of the probe parameters (not probe number)
(value range 1 to 40)
Setpoint
Setpoint for rectangle in 1st axis of the plane (X for G17)
Setpoint for rectangle in 2nd axis of the plane (Y for G17)
Measurement path
Safe area
Starting angle
Absolute incremental value
1. Incremental infeed of the 3rd axis of the plane (Z for G17)
Infeed direction via sign of S_ID. For measurement of spigot, rib and rectangle outside,
S_ID is used to define the lowering to measuring height.
2. Consideration of a protection zone
For measurement of hole, groove and rectangle inside and a protection zone, S_ID is
used to define the overtravel height.
Diameter or length (width) of the protection zone
For "Measure rectangle": Width of the protection zone of the 2nd axis of the plane
2)
2)
5)
5)
5)
2)
7)
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Measuring cycles