Turning Measurement - Outside Diameter (Cycle974, Cycle994) - Siemens SINUMERIK 840D sl Programming Manual

List of the result parameters
The measuring variant "Inside diameter" provides the following result parameters:
Table 3-7
Parameters
_OVR [0]
_OVR [1]
_OVR [2]
_OVR [3]
_OVR [4]
_OVR [5]
_OVR [6]
_OVR [7]
_OVR [16]
_OVR [17]
_OVR [18]
_OVR [19]
_OVI [0]
_OVI [2]
For workpiece measurement with tool offset or correction in the work offset, additional
parameters are displayed, seeAdditional result parameters (Page 342).
3.2.7

Turning measurement - outside diameter (CYCLE974, CYCLE994)

Function
With this measuring variant, the outer diameter of cylindrical workpieces can be measured.
The diameter and radius programming are supported.
The measurement result (measurement difference) can be used as follows:
● Correction in the work offset (only for measuring without reversal, 1-point measurement)
● Offset of a tool
● Measurement without offset
Measuring cycles
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Machine manufacturer
Please observe the information provided by the machine manufacturer.
"Inside diameter" result parameters
Description
Diameter setpoint (note measuring axis S_MA)
Diameter setpoint in 1st axis of the plane → only for S_MA=1
Diameter setpoint in 2nd axis of the plane → only for S_MA=2
Diameter setpoint in 3rd axis of the plane → only for S_MA=3
Diameter actual value
Diameter actual value in 1st axis of the plane → only for S_MA=1
Diameter actual value in 2nd axis of the plane → only for S_MA=2
Diameter actual value in 3rd axis of the plane → only for S_MA=3
Diameter difference
Diameter difference in 1st axis of the plane → only for S_MA=1
Diameter difference in 2nd axis of the plane → only for S_MA=2
Diameter difference in 3rd axis of the plane → only for S_MA=3
D number
Measuring cycle number
Measuring variants
3.2 Measure workpiece (turning)
Unit
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
-
-
99