Siemens SINUMERIK 840D sl Programming Manual page 304

Parameter lists
4.1 Overview of measuring cycle parameters
No. Screen Cycle pa‐
form pa‐ rameters
rameters
2 Selection
S_KNUM
3 Selection
S_KNUM1
4 Icon+
S_PRNUM
number
304
Meaning
Correction in work offset (WO) or basic WO or basic reference
Val‐ UNITS:
ues:
TENS:
0 = No correction
1 to max. 99 numbers of the work offset or
1 to max. 16 numbers of the basic offset
HUNDREDS: Reserved
THOUSANDS: Correction in WO or basic WO or basic reference
0 = Correction of the adjustable WO
1 = Correction of the channel-specific basic WO
2 = Correction of the basic reference
3 = Correction of the global basic WO
9 = Correction of the active WO or for G500, last active channel-specific basic WO
TEN THOUSANDS: Coarse or fine correction in the WO, basic WO or basic ref‐
erence
0 = Fine correction
1 = Coarse correction
Correction in tool offset
2), 4)
Val‐ UNITS:
ues:
TENS:
HUNDREDS:
0 = No correction
1 to max. 999 D numbers (cutting edge numbers) for tool offset;
for additive and setup offset, see also S_DLNUM
THOUSANDS: 0 or unique D number
TEN THOUSANDS: 0 or unique D number
1 to max. 32000 if unique D numbers in MD have been set up
HUNDRED THOUSANDS: Tool offset
0 = No specification (offset in tool geometry)
1 = Offset of length L1
2 = Offset of length L2
3 = Offset of length L3
4 = Radius offset
ONE MILLION: Tool offset
0 = No specification (offset of the tool length wear)
1 = Tool offset, additive offset (AO)
Tool offset value is added to the existing AO
2 = Tool offset, setup offset (SO)
SO (new) = SO (old) + AO (old) offset value, AO (new) = 0
3 = Tool offset, setup offset (SO)
Tool offset value is added to the existing SO
4 = Tool offset, geometry
TEN MILLION: Tool offset
0 = No specification (offset in tool geometry normal (not inverted))
1 = Offset inverted
Number of the field of the probe parameters (not probe number)
(default=1)
6)
2)
2)
5)
5)
5)
2)
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
2)
Measuring cycles