Siemens SINUMERIK 840D sl Programming Manual page 314

Parameter lists
4.1 Overview of measuring cycle parameters
Table 4-6 CYCLE998 call parameters
No Screen form Cycle pa‐
. parameters rameters
1
S_MVAR
2 Selection
S_KNUM
3
S_RA
A, B, C
4 Icon+
S_PRNUM
number
314
1)
Meaning
Measuring variant (default=5)
Val‐ UNITS: Contour element
ues:
5 = Measure edge (one angle)
6 = Measure plane (two angles)
TENS: Reserved
HUNDREDS: Correction target
0 = Only measurement and no correction of WO
1 = Measurement and determination and correction of the WO (see S_KNUM)
THOUSANDS: Protection zone
0 = No consideration of a protection zone
1 = Consideration of a protection zone
TEN THOUSANDS: Measurement with spindle reversal (difference measurement)
0 = Measurement without spindle reversal
1 = Measurement with spindle reversal
HUNDRED THOUSANDS: Measurement at an angle or paraxial
0 = Measurement at an angle
1 = Measurement paraxial
Correction of work offset (WO) or basic WO or basic reference
Val‐ UNITS:
ues:
TENS:
0 = No correction
1 to max. 99 numbers of the work offset or
1 to max. 16 numbers of the basic offset
HUNDREDS: Reserved
THOUSANDS: Correction of WO or basic or basic reference
0 = Correction of the adjustable WO
1 = Correction of the channel-specific basic WO
2 = Correction of the basic reference
9 = Correction of the active WO or for G500 in last active channel-specific basic
WO
TEN THOUSANDS: Coarse or fine correction in the WO or basic WO or basic
reference
3)
0 = Fine correction
1 = Coarse correction
Correction target coordinate rotation or rotary axis
Val‐ 0 = Correction target coordinate rotation around the axis that results from param‐
ues: eter S_MA
4)
>0 = Correction target rotary axis. Number of the channel axis number of the rotary
axis (preferably rotary table). The angular offset is made in the translatory part of
the WO of the rotary axis.
Number of the field of the probe parameter
(default=1)
2)
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Measuring cycles