Siemens SINUMERIK 840D sl Programming Manual page 171

Procedure
The part program or ShopMill program to be processed has been created and you are in the
editor.
Parameter
G code program
Parameter Description
Measuring
● Standard measuring
method
method
● 3D probe with spindle
reversal
● Align 3D probe
PL Measuring plane (G17 - G19)
Calibration data set (1 - 40)
(only for measuring without
spindle reversal)
Parameter Description
Correction tar‐
● Measuring only (no offset)
get
● Work offset (save measured values in a settable WO)
● Tool offset (save measured values in the tool data)
TR Name of tool to be corrected
D Cutting edge number of tool to be corrected
∅ Hole diameter setpoint
α0 Contact angle
Measuring cycles
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
1. Press the "Meas. workpiece" softkey.
2. Press the "Hole" softkey.
3. Press the "1 hole" softkey.
The input window "Measure: 1 hole" opens.
Unit
-
1)
2)
-
-
4)
3.3 Measure workpiece (milling)
ShopMill program
Parameter Description
T Name of the probe
D Cutting edge number (1 - 9)
Measuring
● Standard measuring
method
method
● 3D probe with spindle
reversal
● Align 3D probe
Calibration data set (1 - 40)
(only for measuring without
spindle reversal)
X Start point X of the measure‐
ment
Y Start point Y of the measure‐
ment
Z Start point Z of the measure‐
ment
3)
Measuring variants
Unit
-
-
-
1)
2)
-
mm
mm
mm
Unit
-
-
-
mm
Degrees
171