Siemens SINUMERIK 840D sl Programming Manual page 123

Parameter Description
X0 / Y0 / Z0 Reference point
X1/ Y1 / Z1 Position 2. Edge referred to X0 / Y0 / Z0
DFA Measurement path
TSA Safe area for the measurement result
Measurements Number of measurements at the same location (1-9)
Note
When the calibration is performed for the first time, the default setting in the data field of the
probe is still "0". For this reason, the TSA parameter must be programmed > probe ball radius
to avoid the alarm "Safe area exceeded".
Measuring variant, turning on a milling machine (only 840D sl)
Procedure
The part program or ShopTurn program to be edited has been created and you are in the editor.
Parameter
ShopTurn program
Parameter
T
D
F
X
Y
Z
Measuring cycles
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
1. Press the "Meas. workp." softkey.
2. Press the "Calibrate probe" softkey.
3. Press the "Radius at edge" softkey.
The input window "Calibrate: Radius at edge" opens.
Description
Name of the probe
Cutting edge number (1 - 9) -
Calibration data set (1 - 40) -
Calibration and measuring
feedrate
Start point X of the meas‐
urement
Start point Y of the meas‐
urement
Start point Z of the meas‐
urement
3.3 Measure workpiece (milling)
Unit
-
mm/min
mm
mm
mm
Measuring variants
Unit
mm
inc
mm
mm
-
123