Measure Tool With Toolholder That Can Be Orientated - Siemens SINUMERIK 840D sl Programming Manual

ShopMill program
Parameter Description
Y Start point Y of the measurement mm
Z Start point Z of the measurement mm
List of the result parameters
The measuring variant "Drill" provides the following result parameters:
Table 3-44
Parameters
_OVR[8]
_OVR[9]
_OVR[10]
_OVR[11]
_OVR[27]
_OVR[28]
_OVR[29]
_OVR[30]
_OVI[0]
_OVI[2]
_OVI[3]
_OVI[5]
_OVI[7]
_OVI[8]
_OVI[9]
3.5.6

Measure tool with toolholder that can be orientated

Overview
The functionality is designed for a specific configuration on turning machines (turning/milling
machines). As well as the linear axes (Z and X) and main spindle, the turning machines must
have swivel axis about Y with accompanying tool spindle. The swivel axis can be used to align
the tool on the X/Z level.
Preconditions
● The lateral surfaces of the tool probe should be aligned parallel to the relevant axes
(machine or workpiece coordinate system in the 1st and 2nd axis of the plane). The tool
probe must be calibrated in the measuring axis and direction in which measuring will be
performed.
● The tool to be measured must be active with its tool offset values when the cycle is called.
Measuring cycles
Programming Manual, 12/2017, 6FC5398-4BP40-6BA1
Unit
"Drill" result parameters
Description
Length actual value L1
Length difference L1
Length actual value L2
Length difference L2
Work offset range
Safe area
Permissible dimensional difference
Empirical value
D number
Measuring cycle number
Measuring version
Probe number
Empirical value memory
Tool number
Alarm number
Measuring variants
3.5 Measure tool (turning)
Unit
mm
mm
mm
mm
mm
mm
mm
mm
-
-
-
-
-
-
-
277